link text

POTC (AWE) - The Return of the Dutchman Part 2

link text

POTC (AWE) - The Return of the Dutchman Part 1
Reprinted bermudagirl50 in youtube，Thank for bermudagirl50

All the user names contain numbers will be deleted according to our rules.
You have to use only English letters, no numbers allowed.

It is not good to make the deck with 0.5mm walnut planks, you are suggested to change into 1mm walnut planks, and polish them after being assembled. There is no need to make the opening of the cannon on side board too polished, as shown in the picture is the bump edge of the cannon opening , it looks better.

1mm walnut planks

Buyer shows of the black pearl

It seems not bad, this is the first time sampling, later we will do the second time, make some improvements for the hull.

Attach the 1mm thick planks to the hull, then cut the extra part, polish the surface, and paint it at last. It seems not bad, this is the first time sampling, later we will do the second time, make some improvements for the hull.

link working Video text
3d scan hull ship body.

I scan the hull in order to make correction for the hull via 3D software, and at the end get the exact data for the ribs and the keels.
It takes 60,000 USD to buy this scan system, and the scan service for once will also be very expensive.

3D print

Draw the outline of the designing picture from the original manufacturer, ensure the basic shapes for keel, rib, deck and side decks, with the help of wasa designing picture, to figure out the gradient of the mast and the cover for the whole model. At last, use laser machine to cut the panels and do the sample.